Safe diagnostic order
- Complete normal shutdown and allow hot or wet components to reach the state specified by the manual before packing.
- Remove, wash and fully dry pads; clean only approved surfaces and keep grit away from the underside.
- Empty, rinse, leave or prepare the liquid system exactly as the model's storage section requires.
- Inspect and loosely route the cable, connector, station, tether and anchor hardware; separate damaged items from the kit.
- Choose a stable dry location within documented temperature and humidity limits and follow exact battery or station maintenance guidance.
End the last session completely
Use the documented retrieval and shutdown order, then disconnect approved power equipment. Do not pack a robot that is warm, wet or carrying a dirty cloth. Inspect the housing and underside for residue without spraying liquid into openings. If the unit was exposed to condensation, a spill or unexpected rain, follow official drying or service guidance rather than placing it in a closed case. Storage should preserve a known safe state, not hide an unresolved alert.
Keep moisture out of the pad system
Remove washable cloths and clean them by their exact instructions. Let them dry completely in a clean ventilated place before putting them in a container. Damp stacked pads can develop odor, contamination or distortion and may transfer moisture to the robot. Store clean and used cloths separately and protect them from lint and grit. Do not leave a pad compressed under the robot if the maker directs removal, and do not attach a substitute fabric for storage.
Prepare the reservoir for idle time
Models differ on whether fluid should be emptied, rinsed or otherwise managed. Follow the long-storage section and the solution label. Never leave a homemade mixture in the system or flush it with an unapproved chemical. Wipe spills and inspect the cap and seal. Protect fluid from children, pets and temperature extremes, retaining its original labeled container. If the robot could be exposed to freezing conditions, do not guess that an empty-looking tank means all internal passages are safe.
Protect cords and safety equipment
Coil cords in broad loops without tight bends, knots or pressure on connector joints. Keep caps and locks clean and prevent heavy objects from crushing adapters or stations. Inspect the rope, carabiner and anchor components, and label any damaged part so it cannot be reused accidentally. Store all exact accessories and the manual together. This reduces the chance that a future user reaches for a similar-looking but unapproved adapter, cloth or restraint.
Return from storage as a recommissioning
Before the next use, repeat the full safety inspection and the manufacturer's power or backup-system preparation. Check for corrosion, pest damage, moisture, swelling, cable stiffness, pad distortion and changed app or support requirements. Test startup on a low reachable compatible pane with the required restraint. A robot that worked before storage is not automatically ready for elevated glass months later. Record the storage duration and any changed behavior for support.
When to stop
- Do not store or recommission a wet electrical unit, swollen battery area, damaged cord, frayed tether, cracked reservoir, mildew-contaminated pads, pest-damaged wiring or equipment with an unresolved attachment or power fault.
Exact-model instructions take precedence
Fluid-path preparation, battery state, station care, environmental limits and pad removal vary. Use the exact model's short- and long-storage instructions, not a generic appliance routine.
Questions readers ask
Should solution stay in the robot tank?
Only if the exact storage instructions say so. Models and fluids differ, especially for long idle periods.
Can pads be stored on the robot?
Follow the manual, but never store dirty or damp pads against the unit. Fully dry them and protect them from grit.
Does the backup battery need periodic charging?
Use the exact schedule and method provided for the model. Do not invent a universal interval or use an unapproved charger.